Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Anyone got ideas about this error. It seems to be occuring on most of the ports on my Cat4006 SwitchThere are no problems due to this error but it don't look good.CDP-3-SENDFAIL:Transmit failure on portUDLD-3-SENDFAIL:Transmit failure on port 1/1It h...
I am trying to configure ppp multilink over to existing serial lines. I have used the following config on both endsip subnet-zero!!!!!!interface Multilink1 ip address 10.201.10.2 255.255.255.0 no cdp enable ppp multilink multilink min-links 2 no ppp ...
Currently we a in a peroid of migrating with our WAN from leased line to Frame Relay.Here is the problem. All VLAN 1 traffic is currently routed via the new FR network for testing. All other VLAN's are routed via the old leased lines. If I ping from ...
I have just installed the upgrade the to CW2k. I upgraded from 3.1 to 3.3.The upgrade included cd-one, java patch and RME upgrade.I did a fresh build after un-installing CW2k completely. Everything went well....until I tried to put Campus Manager bac...
We have various nodes on our network experiencing routing problems. Reverse routed packets to various nodes are being passed to our Internet Firewall instead of the correct Vlan.Taking a look at the CEF (show ip cef) table for MSFC1 the nodes experie...
Check that it has written the changes. I have experienced a few issue where, even though I checked the "copy to start" option, the changes were no written. I always run a batch file to write the changes to all devices every dayRegardsBarry Hart
