Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. I am not sure whether this is the correct place for my question but here goes. I have recently purchased CML Personal but I will be leaving my employer in the near future. I am confused about whether or not I will be able to link my Cisco acco...
Hi. I need to install c2960x-universalk9-mz.150-2a.EX5 on a new switch we are purchasing that will be added to our existing stack. When I search for this particular IOS version I get taken to the Catalyst 2960X-24PS-L switch page on the Cisco website...
Hi. We have a 2 switch core stack and a stack of 4 access switches connected together over 2 etherchannel links but one of the links has dropped and we don't know why. Interfaces on both sides are showing as down, down(notconnect) Core - C9500-16XAcc...
Hi. We're having an issue with a particular VLAN on our network. To summarise - we have a Cisco switch connecting to a non-Cisco firewall. The switch's MGMT IP is on the VLAN (100), with the gateway of that VLAN sitting on the firewall.VLAN 100 is al...
Hello,We are having AV equipment installed in our office but the installation team is having issues getting the hardware to connect via its URL. We have been asked to verify that HTTPS is running on the LAN the devices are connected to. Looking at th...
Hi. Sorry I should have said - it's a L2 switch which also has another VLAN on (as well as the usual VLAN1 which is shutdown). As for version I'll have to check again when I get access to a switch. It is a 2960X switch
Hi Flavio,Thanks for the reply. I'll give the duplex and speed change a go. I was mistaken - our core switch is using 9500 not 9200 but it probably doesn't make a difference in this respect.
