Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am working on an old PIX 501 w/ 6.3(5) software, it already have remote access VPN setup and works fine but now it needs a L2L set up. One thing is I am trying to do all the work remotely over the VPN or ssh to the device. I do not know what is...
OK I wondered about that, when it died is when I did the crypto map emds-map interface outside command. I will try it later on and see. So you could have multiple L2L VPNs as long as they use the same crypto map name and a different sequence number a...
OK here is the config as it stands now with a little change of IPs and Passwords: Saved:PIX Version 6.3(5)interface ethernet0 autointerface ethernet1 100fullnameif ethernet0 outside security0nameif ethernet1 inside security100enable password ***** en...
My main problem is that when I put in the commands the normal remote access VPN that I need to connect to the computer that is getting NATed breaks and I cant get to it to see if the other works. One problem I have had in the past is the other side t...
