Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to make a simple configuration change on an AIR-AP1242AG-A-K9 wireless access point. When I try to save the change using the "copy run start" or "write mem" command I get the following error message after the unit trys to build the confi...
Thank you for the advice. That is what I was afraid of, looks like I have some files to delete (times 74), the number of units I am converting. Bob IbachTelecommunications ServicesWestern Washington University 360-650-6812 [email protected]
Dan,You are terrific!!!. I have 20+ crash files in the flash directory so I deleted 2 of them and tried to save my configuration changes just see what would happened and it worked. I suppose it is a good idea to remove the rest of the crash files h...
