Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Description the issue:I have two ASAs which were configured Active / Standby Fail-over. The issue is one of three servers that reside under this 10.71.0.0/24 subnet cannot reach the primary gateway 10.71.0.1. However, it is able to reach the standby...
Hi, I had some trouble to let the ASA sub-interfaces to be able to reach each other. Here is the topology diagram description:one 9300 SW has port 47 and 48 link to ASA 5525 port 1 and 2 via port channel. I create two sub-interfaces on ASA under PO1 ...
I had the exact same situation after a power outage last Friday. The RAID card cannot be detected from C240 M4 since then. I had no clue what's happened.@John Sharma Was your issue resolved? Was it a firmware bug or hardware issue?
Hi Radio_City, I think you are right. All configure was actually correct. The description of port-channel was added by me when I did port tracking remotely but I did not pay attention to the port-channel number. When they remotely reconnected the net...
Hi, Here is the diagram:Each Stack has a port to form one channel group so whichever the ASA device is active, the port-channel will link to both stacks. Let me double check if I actually configured the correct channel groups.
Hi, I checked both ASA 5525 pair, none of them can see mate SN #. I do not see the port-channel issue, they are all up in use. PCCFW1-2/pri/act# show port-channel summaryFlags: D - down P - bundled in port-channelI - stand-alone s - suspendedH - Hot-...
Hi, I just got a chance to grab the output from the devices. I noticed that both ASA cannot ping each other using these port-channel subinterfaces. I have another backup site which has identical topology and connections between the ASA and switches. ...
