Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone, I need help with the below scenario: As shown in the attached image there's a two sites connected throw a Cisco ISR1004 we want to make a DR for site A in site B. My questions is:How to connect the both sites with same network address...
Hello Dears, Good Day! I have the below products:No.ProductNote1C6880-X-LETwo in VSS mode2C9300-24T-ETwo in stack mode3WS-C2960XR-48LPD-I/ The list of licenses am trying to activate:C6880-DNA-EC6880-DNA-E-3YC9300-NW-E-24C9300-DNA-E-24-5YC2960XR-DNA-E...
As mentioned I have an existing Datacenter in site B which need to communicate with site A and i want to add servers to site B which will handle the Site A VMs when a failover occur.My VMs will startup at site B but the gateway in site A is shut down...
Hello, We have many clients which need to connect to the VMs with it's ip address. if we change the VM ip address we need to change all clients which will take forever. So i need to preserver the vms which the same ip address when they startup at sit...
Hello Paul, What i mean by site failure is that all the site for some reason goes down and i has a replication solution that replicate all my virtual machines to site B and automatically start them up. so what i want is when my virtual machines start...
