Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 3750 stack as my aggregation point (10.10.10.3). Outbound traffic goes to ASA5510 (10.10.10.1) as do all my client gateways. I recently received a 1910 (10.10.10.10) to use as VPN router from an ISP vendor. I simply want to route traffic ...
Can anyone summarize the difference between Conduit and Outbound? I tried to allow traffic on specific ports to just two IP addresses with conduit statements, but they did not allow any of the traffic I was hoping. If I put a general Outbound permi...
I have a PIX 515 and I'm stuck back at 5.3 but I need to add access to my entire protected range to/from about a dozen unusual ports so I can run hosted Java applets. I was given the ports, and the IP addresses, but it took 45 DAYS!!! for my provide...
I basically went with scenario 1, except that the 3750 sends 208 data to the 1910. Scenario 2 didn't work as I couldn't get the ASA to do the routing back to the inside network, even with that allow same security intra-interface option enabled. Sce...
Check the IP settings on the laptop? Is it in the .1 subnet, and have a functional gateway setting?Crossover ethernet cable? Are you sure you want a crossover and not a straight? I don't know, just asking a question.
