Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
At Cisco Live I was able to get into a lab where the advisor showed a feature that I cannot find any information on how to implement or use. It was quick example. On the switch you can enable a packet trace and actually watch the packet traverse from...
Yes thank you by forcing the config register "config-register 0x2102" is definitely a great idea. It would be nice if IOS would be updated to confirm however. Anyone of has had to force a production switch to rommon to set the registry can be a ni...
Thank you that is very interesting so if it doesn't show that the Startup configuration is not going to load by default that means that the config register is 0x2102 I would say that is something that to me leaves some room for error since it doesn't...
Can you explain how any of the data reflects 0x2102 or oxf ? Sorry but I'm not seeing any correlation. Please point out where I can confirm 0x2101 after executing show romvar ? Thank you
Not seeing it here ROMMON variables:BOARDID="38"ETHER_PORT="2"PS1="rommon ! >"MAC_ADDR="3C:26:E4:3B:23:00"RETRY="0"SWITCH_NUMBER="1"MODEL_NUM="C9600-SUP-1"SYSTEM_SERIAL_NUM="FDO263203FN"MOTHERBOARD_SERIAL_NUM="FDO263203FN"TEMPLATE="core"BAUD="9600"IM...
I do not see any show commands that would show me the registry will run a configuration after upgrading. The only command I could see that would provide any output show registry brief and it gave to me a lot of nonsense,. In all respects. Is ther...
