Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently installed a 3560 switch in a network with 2 existing 2960 switches so we could route between VLANs. The VLAN routing appears to be working fine but when I attempt to move from the 2960 to the 3560 all of them move successfully except the A...
I have created a new VLAN (VLAN 2) in addition to an existing VLAN 1. Both Vlans have interface addresses on a Catalyst 3560. All of the network devices can see one another including talk but when I try and access a device in one VLAN from a pc in an...
The switch does not recognize that command.I cannot ping the server from the switch when I attache to the switch. When it is attached to the 2960 - no problem!The ARP table on the 3560 when I attach the server to it shows the correct ip associated wi...
The hardcoding didn't help.Attached is the arp and mac-address-table dynamic - I'm not sure if they are the same thing as you asked about. I don't know specifically how to show the cma table. Please excuse my ignorance.
The server cannot ping any other hosts.The only items I see in the logs are changing state from down to up and vice versa when I plug into and unplug from the interface.22:33:17: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/4, change...
Portfast and Bpduguard are enabled on both ports.I did clear the mac-address-table on the 3560. At least I issued the 3 variations of the command that I found.Attached is port information.
