Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've an cisco 3640 with a VWIC-2MFT-E1 network module. Can anybody tell me why i cant configure any voice-port? without able to configure voice-port, i cant assign any port for my "dial-peer voice xx pots". Anybody has any solution?what im trying to ...
I've only got this from my controller E1Vertigo(config-controller)#?Controller configuration commands: channel-group Specify the timeslots to channel-group mapping for an interface clock Specify the clock source f...
Thanks for the reply. After reading the data sheet, i got a clearer understanding. It says i need either NM-1FE2W, NM-1FE1R2W, NM-2FE2W to get one serial channel group for my VWIC-2MFT-E1. Am i right? Meaning to say, if i get one of those WIC, im abl...
