Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to replace the Cisco logo in the AnyConnect client with our own. I have followed the instructions below, but have not had any success. Has anyone gotten this to work?http://www.cisco.com/en/US/docs/security/vpn_client/anyconnect/anyconn...
The goal: To allow Clientless(portal) connections with only username/password authentication (LDAP in this case) while requiring two-factor (LDAP & Certificate) authentication for AnyConnect connections.The config: Since the auth methods are configur...
I am trying to setup a VPN backup solution for one of our MPLS connected branch offices. I've configured the tunnel interfaces as required and that is working as expected, however I'm looking for suggestions on which direction to go with the routing...
My config is almost identical, however when using web launch, the AnyConnect client will still establish a connection using the 'WebVPN' tunnel group and will do so with only LDAP authentication.group-policy DfltGrpPolicy attributes vpn-tunnel-protoc...
Interesting that you should mention removing the tunneling protocol from the group policy. I have done exactly this and the AnyConnect client still connects using that profile/group policy pair even though the only protocol specified is "webvpn". I...
Floating static routes were not something I was familiar with until you mentioned them. Certainly seems simple enough. I suppose I would have to redistribute both BGP and the floating statics into the IGP at each site to achieve the desired results...
I definitely considered that as an option. In fact in the lab I was able to get it to work using the "local-as" command which allowed me to change the AS on one of the routers (at the central site for example) while spoofing the original AS that the...
