Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,the following problem appeared when i enabled syslog on ASA-5510 : every minute it generates 8-10 messages with the following text:incoming SNMP request (736 bytes) from IP address <CiscoWorks' IP address> Port 2946 Interface "inside" exceeds ...
Well, i ran packet capture and i noticed the following:IF-MIB::ifInDiscards.11 (1.3.6.1.2.1.2.2.1.13.11): unSpecifiedIF-MIB::ifOutErrors.11 (1.3.6.1.2.1.2.2.1.20.11): unSpecifiedIF-MIB::ifInErrors.11 (1.3.6.1.2.1.2.2.1.14.11): unSpecifiedIF-MIB::ifOu...
I finally found what the problem was. Yes, it logged into syslog.log , and showed them as invalid. The problem was that i couldnt generate reports, because there were no data. Well, the problem was the source interface's IP address. I didn't configur...
The windows HOSTS file is located in your Windows\System32\Drivers\etc . Open it with notepad and in the bottom add your devices' ip addresses and their name EXACTLY as you have entered in CiscoWorks. Then click save and try again.
