Hello,
Can anyone tell me how to configure a switch port for a pc and IP phone. If we are assigning singe port to two different vlan, how switch will separate traffic ?
Regards,
Abhijith
Hi All,
We are managing cisco 3560x switch and i am not able to see the FAN serial number from show inventory comand. It is showing other details like power supply, network module and SFP's. But i could see same details in other cisco platforms.
C...
Hello All,
I observed Interface TenGigabitEthernet1/0/0, link down due to remote fault on ASR1006 and the link is down. May i know what is the exact issue ?
Jul 21 04:04:06.871 EDT: %IOSXE_SPA-6-UPDOWN: Interface TenGigabitEthernet1/0/0, link down...
Hello All,
I have a 3850 stack, we RMA one of the member because it was faulty. I copied the IOS image via connecting ethernet cable between the new switch with one of the stack member. Now upgraded the new switch(Separately, not connected to stack)....
Hi Joseph,
Thanks for replay. I understood that we are using two different VLAN. My question is that if a packet coming from PC, how the switch port will identify that is coming PC not from IP phone?
Hi Julio,
In some other Cisco switch series, if we give the command show inventory, I could see fan details such as serial number, part id etc. So my question is that why some switch series show all details and others don't ?
Hello Leo,
sh int TenGigabitEthernet1/0/0TenGigabitEthernet1/0/0 is down, line protocol is down------------------------------------------------------------------------Description: -------------------------MTU 9192 bytes, BW 10000000 Kbit/sec, DLY 10 ...
Hello,
As per my knowledge, delete flash:/vlan.dat command ask for confirmation and delete /f /r flash:vlan.dat won't. Is that the only difference ?
Thanks,
Abhijith
.jpg "VIP Expert"){kind=icon}
.jpg "Hall of Fame Master"){kind=icon}
