About abhdivak

abhdivak · 03-14-2017

Hello, Can anyone tell me how to configure a switch port for a pc and IP phone. If we are assigning singe port to two different vlan, how switch will separate traffic ? Regards, Abhijith

abhdivak · 03-14-2017

Hi All, We are managing cisco 3560x switch and i am not able to see the FAN serial number from show inventory comand. It is showing other details like power supply, network module and SFP's. But i could see same details in other cisco platforms. C...

abhdivak · 07-21-2016

Hello All, I observed Interface TenGigabitEthernet1/0/0, link down due to remote fault on ASR1006 and the link is down. May i know what is the exact issue ? Jul 21 04:04:06.871 EDT: %IOSXE_SPA-6-UPDOWN: Interface TenGigabitEthernet1/0/0, link down...

3850 stack - replacing one member · 07-20-2016

Hello All, I have a 3850 stack, we RMA one of the member because it was faulty. I copied the IOS image via connecting ethernet cable between the new switch with one of the stack member. Now upgraded the new switch(Separately, not connected to stack)....

abhdivak · 07-19-2016

Hello All, How IP addresses work on Layer 2 switches and In real time, how we are monitoring L2 switches ? Thanks, Abhijith

abhdivak · 03-15-2017

Hi Joseph, Thanks for replay. I understood that we are using two different VLAN. My question is that if a packet coming from PC, how the switch port will identify that is coming PC not from IP phone?

abhdivak · 03-14-2017

Hi Julio, In some other Cisco switch series, if we give the command show inventory, I could see fan details such as serial number, part id etc. So my question is that why some switch series show all details and others don't ?

abhdivak · 07-21-2016

Hello Leo, sh int TenGigabitEthernet1/0/0TenGigabitEthernet1/0/0 is down, line protocol is down------------------------------------------------------------------------Description: -------------------------MTU 9192 bytes, BW 10000000 Kbit/sec, DLY 10 ...

Hello, · 07-20-2016

Hello, As per my knowledge, delete flash:/vlan.dat command ask for confirmation and delete /f /r flash:vlan.dat won't. Is that the only difference ? Thanks, Abhijith

Hello Leo, · 07-20-2016

Hello Leo, What is the difference between the commands delete flash:/vlan.dat and delete /f /r flash:vlan.dat ? Thanks, Abhijith

Member Since	‎12-29-2015 09:53 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	32

User Statistics

User Activity

Switch port configuration for a pc and IP phone

show inventory command does not show the FAN serian number ?

Interface TenGigabitEthernet1/0/0, link down due to remote fault

3850 stack - replacing one member

How IP addresses work on Layer 2 switches ?

Hi Joseph,

Hi Julio,

Hello Leo,

Hello,

Hello Leo,