Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,
I need some help again.
How to configure a switch so that only a specific OU in active directory can log in to manage it, all changes to the config are logged somewhere, and vlans are set dynamically based on Active Directory OU of the...
Hi Guys, I need some help.
How can I configure two switches so that a single device with two NICs can plug into both of them in an active/standby or load balance team without creating a loop?
Is it possible to test using packet tracer?
Attached...
Hi Jean,
Thank you for your help.
For what I could understand from your explanation, I only have to configure the STP on my switch, the rest (NIC team) is done on the server, correct?
Probably this is a stupid question, but if each nic is on a d...
Hi Sandy,
Thank you for your reply, I will have to read more about it.
This is one of the questions I will have to answer for a job interview, I need to know how to configure the switches. Do you know any software or application that can help me ...
