Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Folks,I'm pretty new to Cisco's so bear with me. I'm switching my office network to a new internet provider, who gives me 8 ip addresses: xxx.xxx.73.128/29The ISP requires that I dialup using PPPoE, and use IP unnumbered.On my side, I use 2 Cisco ...
I just had that second 2811 on hand as a backup so I used it. I didn't want to cause too much downtime on Router 2 to experiment with the config.Ideally in the long run the configuration would be a single 2811 router, or coupled with a 800-series rou...
Here goes: it's exactly the same for both. Both routers have 11 FastEthernet intefaces Currently using 2 on eachCisco IOS Software, 2800 Software (C2800NM-ADVSECURITYK9-M), Version 12.4(19b),RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco....
Silly me - indeed the pb was in access list WAN_IN, not a routing issue at all! All working now, thx!Correct me if I'm wrong but it should be OK to get rid of the 1st router altogether, right? I could create the dialer1 interface on router 2, plug th...
