Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, I come across with an issue I did nont expected and honestly I do not know how I can resolve it without impacting the whole network desing. Basically I have three vlan,10,20,30 with their respective subnets: 172.28.28.0/24,172.28.29.0/24...
Hi all,
I am addressing to you hoping someone could help me out in an issue that honestly i do not know how to get resolve.
The thing is that i am testing a customer profile which has been enable under tacacs. This customer would be able to make...
Hi Richard, First of all, I would like to thank you for your support and for your time, thanks a lot. It seems to be that you did understand well the issue because when I applied the config that you thought it might work (disabling proxy-arp) ,well, ...
Hi Paul, first of all I would like to thank you for your time,Well, the main concern is about design/security, in terms of avoiding someone having access to the network with a misconfiguration of the NIC card. I mean, only devices on the 172.28.29.0/...
Hello Geroge,First of all thanks a lot for you response,Well, unfortunately it does not work when configuring access list. (see below the config on the L3 SWITCH)sh access-listsExtended IP access list 12510 permit ip 172.28.29.0 0.0.0.255 any (476 ma...
Hi Richard,
it' been a while. I just wanted to let you know that i found the solution and fortunately the issue is over.
It was just needed to enter , under tacacs config mode,the next command,:
aaa authorization config-commands <<< using this co...
Hi Richard,
First of all , I would like to thank you for the interest shown on this subject, really appreciate.
Answering to your questions:
1. There has not been any change level of any commands on this router.
2. The fact that the command ...
