About BrulinesCisco

BrulinesCisco · 05-20-2010

I have a Cisco ASA 5510 and i'm trying to add a dynamic NAT rule on a sub-interface so that internet traffic will work. When i add the rule it is breaking VoIP inbound calls on a different sub-interface. The VoIP is setup using Asterisk and Sipgate...

BrulinesCisco · 05-15-2010

Hi,I have an ASA 5510 that was originally setup with no VLANs. I have a SIP telephone system on the inside interface. I have now added two sub-interfaces to the inside interface for seperate VLANs as shown below.!interface Ethernet0/0 nameif outsid...

BrulinesCisco · 05-21-2010

Hi PK,After reading your first post i looked more into the SIP inspections and i modified the inspection so that it is specific to the inside interface, using similar commands to below:hostname(config)# policy-map global_policyhostname(config-pmap)# ...

BrulinesCisco · 05-20-2010

the routing table is as follows:Gateway of last resort is *.*.*.174 to network 0.0.0.0C 172.0.0.0 255.255.0.0 is directly connected, inside2C *.*.*.160 255.255.255.240 is directly connected, outsideS* 0.0.0.0 0.0.0.0 [1/0] via *.*.*.174, outs...

Member Since	‎05-11-2010 12:27 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	4

User Statistics

User Activity

Dynamic NAT rule on second interface breaks first interface NAT

ASA 5510 Dynamic NAT on Sub-Interfaces

Re: Dynamic NAT rule on second interface breaks first interface

Re: Dynamic NAT rule on second interface breaks first interface