Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am looking for a little direction here as I am used to working with Cisco gear and have not played with Linksys very much. I will be creating two seperate vlans on the SFE2000P and would like the RV042 to provide the routing capabilities for these...
I am currently designing a wireless solution for a new building on campus. Our goal is to provide coverage to wireless clients via rooftop mounted AP's (specifically 1310's). We have 3 patio areas on 3 different sides of the building and I figured ...
Thanks Rob,I'm really enjoying the opportunity to bounce these questions off such a large number of knowlegable people. I may pursue the possibility of getting a few of the antennas in to test although I am leaning towards the AIR-ANT2506. I just d...
I would recommend that you re-check all your settings for WDS on your controller and make sure you have the latest image on both the AP and WLSE. Refer to this document http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_gu...
Thanks for your help. I initially was trying more of a directional antenna since I didn't want the signal from an omnidirectional interfering with other AP's inside the building. I was hoping to concentrate the signal to a specific area....is this ...
If you are using an AP as your WDS controller instead of WLSM or a light-weight controller and you have more than 60 AP's on your network some of them will not authenticate to WDS. For instance, one 1200 series AP will only handle 60 AP's at a time a...
