Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I installed 8.0 in my lab but have not upgraded production controllers yet. Does anyone who has installed in production have any comments on stability or issues?
Has anyone seen this error before?DOT11-3-TX_PWR_OUT_OF_RANGE: Interface Dot11Radio0 Radio transmit power out of range1410 Bridge ... Cisco documentation simply states "Remove unit from netowrk" ....
Anyone know how to reset the WiSM to factory defaults? Troubleshooting FAQ suggests resetting WiSM and entering "recover-config" at the username prompt, but that did not work. I made a change to one of the gig ports and it brought down the port-cha...
That's how I configured initially. I have reconfigured the port-channels to the original configuration, but the high-order port-channel (that gets dynamically created when the initial port-channel was configured) can't be configured since the port-c...
