Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a pair of ASA_5550 and I need to upgrade the activation key on them. I bought one key and want to apply to both firewalls (primary and secondary). they are both on 8.2 version. Can I do that with 8.2 or I will have to upgrade to 8.3?Regards,
I have the following setup on my internet firewalls:- Outside interface has no standby IP- Inside Interface has a standby IP_Failover is working fine.A month ago, these firewalls failed over to the socondary Firewall. That worked fine until yesterday...
Update:I failed back to Primary and was able to ping the stndby IP but couldn't ping the primary IP and lost internet connectivity.So, there is something going on between the primary firewall and the core switch.
Here they are0013.c480.222 dynamic Yes 5 Gi1/1 (port connected to Primary)0013.c480.111 dynamic Yes 0 Gi2/1 (port connected to secondary)sh mac-address-table int Gi1/1Legend: * - primary entry age - seconds since la...
Sankar:Ok. let give you the whole setup now.******************************************************************************************************************************************Primary firewall: sh verEthernet0/1 : address is 0013.c480.1...
Sankar:I did the capture and the ICMP packet are not hitting the firewall (secondary IP on Primary Unit which is standby now).However, I can ping the switch from the secondary IP but cannot ping the secondary IP from the switch.Thanks alot.
