Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi i am trying to build a ipsec tunnel to access the devices in customer's network.here is the scenario router 192.133.193.242-192.133.193.241 inside Pix 192.133.193.249 outside ------internet-------customer's router----devicesRout...
i have router 3845 and then it's connected with pix and then its connected with vpn tunnel to the customer router. i am here trying to make vpn connectivity for devices. so on router i did static nat statements 10.124.90.124 10.200.200.1. this type o...
i have router and pix connected and i am doing nat on my router. how should i perform nat on router? i have 10.200.200.0 subnet for nat. and 10.124.90.250 actual device ip i need to ssh from cisco side. and 216.46.255.0/26 is thier nat subnet
for my router sh run is too large. sh just added full pix sh run and added router's config vpn relatedPIX Sh run=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2012.09.06 08:58:04 =~=~=~=~=~=~=~=~=~=~=~=Using username "Manager".***********************************...
