Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Larry,Isn't the SNAP layer 2 frame format used for NIC's or devices that you want to translate from EV2 to IEEE 802.3?.It might be a legacy Cisco device.I have never seen an SAP value like that before,I wouldn't know what the SSAP or DSAP that hexide...
You can try this:1.Implement a show ntp association command to see if there are any UDP packets being propagated to your router via IP.2.If not, then try to ping the NTP server from the router you want to recieve NTP advertisements.3.Configure both r...
You would have to enter the NAT commands as follows:ip nat inside source static You must properly configure IP NAT statements that execute proper translation.with you access-list you will have to configure the keyword permit ip any any statement to...
Your configuration will be as follows:controller framing esf linecode b8zs pri-group timeslots !Or you can type ? or questionmark once you enter config mode and follow the instructions there.As an extra tidbit, you must test the T-3 line to discov...
