Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I have installed new IPS 4270 in our Data Center. It is working with default signature configuration.Now I want to monitor all the traffic which are going and coming via IPS. So can anyone tel me the tool name and how to configure it, by wh...
Hi All,I have configured two ASA firewal in failover mode - Active and Standby and two ASA is working in failover mode too, but whenever I fire a command " sh failover" in active ASA then it shows - This host is Active and another is failed. I hav...
Hi All,I have a issue with NAT in ASA 5580 firewal. 1. I have one web server on DMZ zone in ASA firewall with private ip address. Web application is running on webserver, and I can access this web application with private ip address from web server...
Hi Bob, Thank you for your reply. I have downloaded and installed. Now I can perform configuration IPS from IME, But I am not able to monitor traffic events. Can you please help me about minimum configuration in IME so that I can monitor traffi...
Hi Varun, Everything is working fine, but only problem is when i fire the " sh failover " command then primary ASA is showing active and Secondar ASA is showing failed , where as if I login to secondary ASA I can see the synchronized configurat...
Hi Varun, ASA Primary:-ASAPRI# sh run failoverfailoverfailover lan unit primaryfailover lan interface FAILOVER_INT GigabitEthernet0/2failover interface ip FAILOVER_INT 192.168.50.1 255.255.255.0 standby 192.168.50.2ASAPRI# sh fail his================...
