Hi!I would like to know how the failover works. I would like this setup.One interface with wired attached ISP and One interface with 4G(umts) Router.What license do i need to get this to work?Normally interface to my isp never goes down but some othe...
Hi!I´m trying to solve a problem with my asa 5510. I would like to publish applications behind Clientless SSL VPN for different users that will belong to groups created in AD. Do i have to use URL to get to the complete separations for bookmarks and ...
Hi!I´m trying to figure out how i should set post parameters in webvpn (clientless vpn) to Ericom Webconnect App Portal. Anyone with experience of this product that could give me hints? It is an ASP page (like citrix)Regards,Fredrik
Hi!I´m trying to use single sign on in clientless vpn portal. I have my bookmarks in place (rdweb/web servers and cifs share). I would like to just enter user/pass just one time (at the portal loginpage of asa5510). I use radius for my auth (radius a...
Hi!How do i tell my firewall to start listen also on another outside ipadress assigned by my ISP? I have it used on other firewall right now. So my steps would be shutting down ip address assignment off old firewall interface. Assign that ip address ...
Hello again!I´m still struggelin with this. I have noticed something that could be a lead. If i just do a ping from outside (another network) to the secondary IP that ends on .76 i get information in log that icmp is not allowed but if i try to use a...
I have tried this via DAP but i get stuck. How should i configure Connection profiles, Group Policys, Dynamic Access Policies so that user gets different bookmarks and stuff depending on AD group belonging?If i disable DfltAccessPolicy and creates a ...
Hi!Where can i set these parameter setting suggested? I´m using ASA5510 Version 8.4(1) and the post options i have in drop-down list is: CSCO_WEBVPN_USERNAMECSCO_WEBVPN_PASSWORDIs this done via cli? If so how should i enter config mode for a specific...
@Michael Kim: My ISP does not let me have an transfer network, that would have been great! @Icaruso: Do you mean that if i create a nat rule with another outside ip specified without assigning it to an interface or vlan the asa will catch that and do...