Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi ,Want to know bit in depth about BGP full mesh.In a BGP AS (this AS is running some IGP for internal reachbility purpose). There can be two scenarios possible:1. All the routers in AS are running IBGP with each other. 2. All edge routers are runni...
Hi All,We have one router configured with rate-limit on LAN port to restrict incomming traffic to 16MB. The rate limit command is configured since long and now we want to rate-limit it to 17MB to accomodate 1MB more. I am confused about how to calcul...
G'Day everyone,Wondering if anyone could help me out here. I tryingto get my head around this whole dampening thing. I know why you need it,and how to configure it. The only thing I don't know or understand is howto come up with the values (other the...
Hi All,Below is the configuration done on one of the routers. But remote end sites are not getting 10.101.32.0/22 route at remote lactions via BGP. IP address @ FastEthernet0/0 Prim IP:- 10.101.21.254/23 Sec IP :- 10.101.22.254/24Static Route ip rout...
In this case, say at t1 ICMP echo failure happen. Next ICMP request will trigger at t1+60 Sec. track object would wait till configured delay down time (t1+30 sec in this case) and will go down. Default route switchover will take place. As the delay d...
Hi Jerry,I agree with you on this. Routers with IOS version 12.4(13r)T are also providing 255 sec as upper limit. But attached documet says Max. Suppress time can be configured from 1 to 20000 Seconds. The default is 20 seconds or four times of half ...
