Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Folks, We have a codec that can't be factory reset, has a slow flashing power light and a steady alarm light on the front panel.Secondary Ethernet isn't working, and I haven't had access to a com port cable in years...LOL Any ideas where to sta...
Thanks Team, I appreciate all your ideas.Unfortunately I'm going to label this unit and shove it in the back of the cupboard.The only thing I can think of doing is swapping out the PSU. Its looks pretty specific so I'm going to wait till another SX8...
Thanks for that,I've tried that process many times without success. Looking like I have a dead codec.*sigh* Is there an error guide available?The front power LED is slowly blinking and the power LED is a steady red.
Hello Leonardo, Unfortunately I have no activity on that (RJ-45) port or the other two LAN and Touch 10 (RJ-45) ports.It seems that the System Configuration > Network Port wasn't previously configured. *sigh* Thanks very much for your help.Is there ...
