Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I've tried to use the reset to factory default choice in the PDM, but it does not seem to work. Does anyone know the CLI command to do so?Thanks.
Hi, I have a PIX525 that I am setting up (new to PIX) to allow web connectivity from the internet. I can get to the web server (from the inside and outside), however, we have the SQL database for the web content sitting on a server on our inside in...
I have a 4506 that I am building a new 2K3 domain on with multiple vlans and connected to the 4506 is an HP4000 switch through a routed port. I have created a new domain in the 2K3 and an trying to set up a trust to the old 2K domain on the HP4000. ...
Federico,Thanks for your assistance, but I was able to figure it out. I had to create a NAT between the inside server and a DMZ address and then point the webserver in the DMZ to the NAT'd dmz address which of course accessed the internal server for...
Thanks Federico. I am in the process of grabbing logs now. I have attached the pertinent config information so that you can get a better look at what I am trying to accomplishPIX Version 6.3(3)interface ethernet0 100fullinterface ethernet1 100fulli...
