Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,i have some Catalyst 2924XL switches, which i want to monitor with mrtg.I got two OIDs from CISCO-MEMORY-POOL-MIB:ciscoMemoryPoolUsed 1.3.6.1.4.1.9.9.48.1.1.1.5.1ciscoMemoryPoolFree 1.3.6.1.4.1.9.9.48.1.1.1.6.1 When i ask a switch with snmpget ...
Hello,i got an older Catalyst 5500 which is now "new" to me.It has 48 Fastethernet ports and an RSM.After creating five VLANs and the routing between them i realised, that the switch is very (!) slow. Which i dont realy understand.Even if i copy file...
Hello,i have an CAT5500 with RSM module (IOS 12.0)I have configured five vlans and each vlan has its own ip subnet.All subnets are 172.20.xx.0/24If i do a "show ip route" i get:CAT5500-RSM#show ip route Gateway of last resort is not set 172.20.0....
Hello,first - i know, the pix is no router, but ...I have a pix 515 and a Catalyst 5500 switch (with RSM).I like to configure some VLANs and subnets on the Cat5500 and use the pix as firewall for the whole thing.My question is, if i give the PIX an i...
Hello,i have a PIX 515e with Software Version 6.3(1).Ok - i am new to the pix but i can read manuals ...The pix has a runnig-config which i like to change.But i have a problem with the line numbers of the access-lists.As a test i tried to insert a re...
Thanks for your answer - but after all i am more confused than before.Ok - i tried your test commands. But, this worked like it should. No problems with the line numbers.After that i made a new test with the "real" existing access-lists and had still...
