Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Problems to connect a VPN-tunnel between Cisco Pix 515 sw ver.6.3(4) and Checkpoint NG. We have followed the article http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00800ef796.shtml but it doesnt work:Here is an ou...
Hi!Is it possibly to portmap from inside-interface to dmz-interface? (We have a web-server at the dmz-interface. The webserver "responds" at the port 446 and the clients "answers" with port 443) It works fine with portmap from outside-interface to dm...
Hi!Could somebody help me whith an configuration between PIX501 connected to ADSL (dynamic ip-address) and Watchguard FB.When i have "ip-address" as identity in phase1 it works fine. But when the the external ip-address change of the PIX this wont w...
I now have ver 6.2.4 but it did not help.I have questions about:"1.) The SA Lifetime time is diffrent in the Cisco to CheckPoint implementation. Both have to be equal."I use the command "isakmp policy 10 lifetime 86400" and it is equal on the CP. Is ...
Thanks, I´ll follow Your suggestions..I saw a note about "CSCef49154 - pix fails to establish tunnel to 3rd party firewall" for sw ver 6.3(4).Could this affect also?Regards Joakim
OK, then I could set the security level lower on the inside-interface than the dmz-interface and solve this. What about Policy-NAT (new in ver. 6.3), can I use Policy-NAT to solve this?
