Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Can CSS11503 appliance be used for Microsft OCS application servers load balancing ?Please provide is there any write up available for this scenario.Regards,
Two Sites are connected by MPLS link with 2MB bandwidth.Both sites have cisco 2811 routers and 3750 Switches .ISP says they have enabled QoS with IP Precedence 5 for platinum CoS.I have enabled MQS on both the routers with set precendence vlaue 5 and...
There is a MPLS WAN link connectivty between one cetral site and two remote sites.Now the planning is putting 4BRI lines as a bundle(to use aggregate bandwidth) for backup link .Whenever MPLS link goes down BRI lines (4Nos)have to dial and estlablish...
Hello,Sorry for the late reply.Do you have any good document which gives steps to mark the video traffic manually in Edge and Core switches ?Thanks alot.
Hi Prem,Can I use this reachability method in my scenario which has OSPF routing for MPLS and static routing for other LAN Subnets.And static route distribution also there in OSPF .Can you elaborate Object Traking more on this scenario ?Thanks in adv...
Hi Prem,Thanks for your reply.I had tested in the same way only.But the issue is MPLS interface is an fast ethernet interface .If I use backup interface command on this interface then it dials the ISDN line once the line protocol is down .This method...
