Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
ATM sub-interface is up/up but I am not able to ping remote side. Router at the remote end is up and is reachable through LAN.circuit was running well 30 minutes agoany suggestions RegardsImran
Can anybody tell me, how can i check the traffic in and out of the subinterface.as show interface command only shows only traffic on the main interface not on the sub-interface.Thanks in Advance
yes , you right that snmp polling is a way to know the traffic on a sub-interface but my intrest is in knowing how can I check traffic on router ?any suggesstions ?
