[somewhat delayed response]The ACNS software will not be corrupted by a power outage, except in the usual situation where you were doing a software upgrade and the power outage occurred right in the middle of the flash write. If this happens, the so...

I don't want to give the wrong impression -- recovery is far from guaranteed in this situation. It's an unfortunate characteristic of the old software load on this CE. At minimum the disk drive needs to be operational and needs to still contain the...

If you're using the CLI, for the ACNS 4.x to 5.x upgrade all you need is the .bin file. For the CDM-based procedure you need a .meta file and a .upg file to feed into the CDM GUI. The contents of the .upg file are the same as the contents of the .b...

I'm not sure what the problem might be, exactly, but my guess is it's a ddts that's been fixed. If you're still having this problem, I would suggest getting a newer 5.1.x or 5.2.x flash image file (ACNS-.sysimg from the sw center) and installing that...

FYI, what you are seeing is the flash image on a CE that has ECDN 2.x/3.x or ICDN software on it, not ACNS. The image you're seeing boot is supposed to be used only in the internal manufacturing procedure for those software loads and was never inten...