Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to configure WDS running on a WLSM but i can only get my APs WDS state to "state = wlccp_ap_st_leap_auth".I found a command that supposed to fix this problem but my AP which is running IOS version 12.2(15) doenst accept it. The command is...
Can both of the tunnel interface be active at the same time?e.g. Sup1Tunnel 100ip address 10.0.0.1/24mobility 100Sup2Tunnel 100ip address 10.0.0.2/24mobility 100
