Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i have made lab with1 HUB and 2 SPOKE phase 1 dmvpn over ipsec .Also rip routing protocol activated in points. Local networks can access other sites with rip.I also want they can be accessed to the internet over the nat .Any helps appreciated.Her...
Hi all,
On Asa I have configured 2 internal sub-interfaces GigabitEthernet0/3.50 and GigabitEthernet0/3.70.
Config on both interfaces :
GigabitEthernet0/3.50 (vlan50-192.168.50.1/24) security-level is 80.
GigabitEthernet0/3.50 (vlan70-192.168.70.1/...
Thanks for your answeri dont want to restict access between hub and spokes for local communication.they have rip between them.need to access internet for local networks
Thanks for your answer,i would check for both access to internet by local and through tunnel .Whats the best practices? ,also rip is configured on points ,should i write that access-lists too which you mentioned
