Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Gents,How to implement the following design. I would like to guaranty 5% of bandwith of uplink on access switch for each access port. If we don't have congestion, bandwith is not limited on access port.How do it ?Could you pls give the example of thi...
Gents,which values do you recommend on access switches for unicast and broadcast traffic ?For ordinary office user and active user, like developer ?Sometimes devs have a lot of traffic, when copy big images. I think, it should be restrictions in pps....
Gents, could you please explain, what does mean voice vlan?My the existing configuraton: all pc and voip phones are located in vlan 2 in the same subnet.Questions: 1. Should it be the separated vlan (vlan 7)? 2. Or it can be the same vlan (vlan 2),...
Gents,I have strange trouble. I added entry into inINS rules for out RDP access, but it doesn't work. Any advises or suggestions ?PIX Version 7.0(5)The added string isaccess-list inINS extended permit tcp 10.30.65.0 255.255.255.0 any eq 3389 My confi...
Gents,I have pix 515e, 7.0(5), 3 interfaces: inside, outside, dmz.We have the small public ip block zzz.Please see the attachments, my config.I can't connect to zzz.zzz.zzz.72 from inside. From outside all are ok. Why, where is the issue ?Which order...
>Do I need to configure "ip dhcp snooping trust" on the portchannel interfaces between the two Core switches?Yes, if dhcp paket can goes through this interface.But if you don't need dhcp snooping on all ports, you can just disable "dhcp snooping" on ...
Sorry, I didn't see the second slide It seems all ok, but I don't see your access ports or access switches.Access switches should have too "ip dhcp snooping trust" on trunk port and ip dhcp snooping limit rate xxxon each access port.Check your conf...
Hi,You should configure ip dhcp snooping trust on all uplink interfaces (trunks) and interface, where is routed dhcp traffic.Also add ip helper-address on SVI 130.I hope this will help.
HiConfigure the port priority. There is link for c3750: http://www.cisco.com/en/US/products/hw/switches/ps5023/products_configuration_guide_chapter09186a00803947dd.html#wp1039280I think, the same should be for 65xx.
