Had a working config, 6503 fwsm, the route stmt in the Cat pointed to the ip on the fwsm accociated with the same interface (inside) the Vlan40 defined in the switch had an address on the same subnet (class c).Converted this config to a split up clas...
I recently worked out a basic configuration to provide a 3 interface firewalling scheme. Inside, outside, and dmz, on the subnets. 10.200.251.0, 10.200.252.0, and 10.200.253.0 with mask 255.255.255.0. After realizing that I need to upgrade versio...
For a Cat 6503, sup2, I have recently switched from transparent to routed mode for cust reqmts. Can see that fwsm v 3.1 is necessary. Is that compatable with the IOS ia am using ? 17.2(17d)SXB11 , it doesen';t seem to be. Alos, what is the easy w...
Have a FWSM in a cat 6503, had it configured for transparent. ine interface port for in and one for out, one ip address.Now we want to provide a DMZ with a physical port access to dmz. Have three vlans defined on Switch 30, 40 and 50, all are defin...
and here is Catalyst config: (most)upgrade fpd autoversion 12.2service timestamps debug uptimeservice timestamps log uptimeno service password-encryptionservice internalservice counters max age 10!hostname catalyst-6503-b!boot system flash disk0:logg...
It will only allow 4000 characters here so I cannot post the whole config, will include important parts:FWSM Version 3.1(1) !hostname FWSMdomain-name ciscopix.comenable password 8Ry2YjIyt7RRXU24 encryptednamesname 10.200.251.4 pc-1 description test p...
I have a pc on the inside using the inside subnet trying to ping a pc on the outside, on the outside subnet.inside pc 10.200.251.4 255.255.255.224outside pc 10.200.251.35 255.255.255.224trying to continuisly ping each other.I can ping both when I am ...
