Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,We are trying to configuring mac ACLs on our Cisco 6500 with Sup7203B and PFC3B with IOS version 12.2(18)SXD6. Below is the configuration that we used.mac access-list extended test deny any anyinterface g8/2 mac access-group test in172.16.0....
Hi,Just follow the link below and you should be able to get it working. Just remember that gig0/0 of the SSM-20 is the command and control interface and gig0/1 is the sensing interface which is connected to the backplane.http://www.cisco.com/univer...
I assume that the available ip address that you have will be assigned to the outside interface of the PIX506E, is that right? If so you need to configure PAT on the PIX firewall using the 'global' and 'nat' commands.Hope this helps.
