Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi...I got Cisco 3640 & 2621 with NM-1FE2CE1U & NM-1CE1U.1.Can this module work with balanced E-1(120ohm) line?2.We are getting E-1 from SDH ring ,directly till our router.Do we still need E1modem (CSU/DSU) to connect with router Pri port or can conn...
PIX not support HSRP because not use IOS software.But you can use failover/stateful failover on PIX.Required 2 unit of PIX with same hardware & software version.Vipul.
(1) Can we use DB-15-to-BNC Connectors (cable) for 120ohm.(2)If we get clock source from E1 line (E1 from SDH ring) ,is still require E1 CSU or what are the situation ,in which we can avoid E1CSU?Thanks/regards,V. Sharma
Hi....Is both the pix running same software ver.?If yes then first complete config on the PIX ,which you want to make Primary ,then enable failover feature and 2nd Pix put off (power) and connect failover secondary end cable to (secondary )Pix and po...
