Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello I have some domains configured and firewalls added. I would like to move a firewall from, say, domain x to domain y, how can I do that? I read "https://www.cisco.com/c/en/us/td/docs/security/firepower/60/configuration/guide/fpmc-config-guide-v6...
My setup is exactly what is explained here: https://www.cisco.com/c/en/us/support/docs/security/adaptive-security-device-manager/118092-configure-asa-00.html My problem (which off course is now resolved) is : I can't SSH / ASDM to inside interface of...
I want a simple command set, permit some commands (eg: show, dir, ping, traceroute ) but deny en or enable, intended that the user should never go to enable mode. My command set is as follows TACACS Profile PS: Doesn't matter what priv level I use ...
Hello I am on FMC 6.2.3, for visibility purpose (data usage etc) our initial deployment was such that every Site (Firewall) was configured as a separate domain. We are nearing the limit of 50 domains, obviously there are many others "sites" (Firewall...
I have Cisco ASA 5516-x in Active / Standby failover. I upgraded the Firewalls using the following method: 1) set boot image2) reload standby3) make standby as active (now on latest code)4) reload standby (former active)5) no failover active on 'acti...
Thank you for your response. Phase 1 establishes just fine, Phase 2 moans about "Received encrypted packet with no matching SA, dropping" error if i debug. I could have taken logs differently, but they are similar all the time.
