You can not multilink to 2 separate destinations without using SGBP on the remote sites MutiChassis. Please let me know if that is what you are talking about. SGBP assumes that the 2 remotes sites are the same like a NAS. Other then that not poss...

You need to use DNIS and Modem pools. Here is an example configuration. For full details please go to the link listed below. The link is set up for CAS but it is the same for ISDN PRI.http://www.cisco.com/en/US/partner/tech/tk801/tk36/technologie...

I have made it work with external modems but not with the AM modules but i think it can. You can configure each async interface and test to make sure you can connect and pass traffic. If you want them to look like one interface you will then hav...

Change your chat script to the following on both sides.chat-script sillyman AT OK atdt\T TIMEOUT 60 CONNECT\c Here is a list of debugs you can run to see what is happening.debug chatdebug dialerdebug ppp negodebug ppp auth

Here is a one stop shop for modem configuration. Please see link for tip and info on configuration. See the following 2 sections for the answer to your questions. Both are at the link listed below.Fundamental Line Configuration TasksAutomatically Co...