Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After updating a few SG300 28 MP's the switches that needed to be upgrade from a prior to 1.35 version to the newest version everything seemed fine, but the port settings page seems to be stuck loading the GUI, every other page works just fine but th...
I have two new 5516x's. Instruction say to log on at default ip 192.168.1.1 and run ASDM launcher. Problem is that there does not appear to be any ASDM files on either device. I have downloaded the most recent ASDM .bin file, but cannot find the co...
This is a pretty simple configuration. I have six Cisco 300 Series switches in Layer 2 mode. They are all connected using ports in Trunk mode. These Trunks are tagged members of all VLANS.I have one 300 series in layer 3 mode with IP address assig...
I went through the same process a few month's back. Had to manually load the ASDM image using a TFTP server on my laptop, much like upgrading the firmware.
I did finally get my ASA working, fortunately I had a support contract. I recall the Cisco i...
Success!! The instructions attached above worked nearly perfect. The only confusing part was that the new 5516x ASA image uses an .SPA file extension instead of the more common .bin. This threw me for a bit. Once I just accepted that the name was...
C'mon, what kind of response is that? We are working on it... Thanks. Let the guy download the ASDM without a support contract. After all, Cisco should have put it there in the first place... I have two ASA5516X's with the exact same issue. No ASD...
Thanks to both of you for replying. I had a feeling that was the case. The files are definitely not loaded on the devices. I found a Cisco document that details the process of uploading ASA and ASDM.Title is: Upgrade to ASA 9.5 and ASDM 7.5I'll...
