Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,Would like to enquire regarding 2 x WAP4410N access points that we have installed at our site. These devices work fine with the power brick but when conmnected the SG300-28P ports POE lights up, and seems to keep rebooting for some strange ...
Hi Rob,I hope this does not happen with VoIP PABX phones that we shall be getting in the next couple of days! So putting it plainly these switches, which we have purchased 3 units do not support 802.3af properly!?Please guide me to opening whatever ...
There is only this single device wireless AP WAP4410N on the entire switch SG300-28P. Issue is as follows:1) With cable connected in Wireless AP connect other end of cable to switch2) POE indicated lights up on Wireless AP, followed by Yellow (righ...
