Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have several IE-3300-8P2S REV A (meaning they come with an L3 NW AdV license) switches here at the company.
The switches works in L3 for most of their functions, however, routing between VLANs doesn't work. From inside the switch I can ping one S...
No, it's not the lite version.I have some older IE2000 versions with the ip lite license and it works perfectly.This seems more like a problem to me. I'll wait for other suggestions.
The switch not recognize 'ip routing' command and not exist sdm prefer dual-ipv4-and-ipv6 template.The ipv6 unicast-routing command was accepted, but it still didn't work.
Hi, how are you? Thank you for your reply, but I've already tried that solution. This switch also doesn't accept the 'sdm prefer routing' command. It only has the 'sdm template default'. See:show sdm prefeSW-POCVSA-01#show sdm prefer The current temp...
Hi, now I can't post the print but: The license is confirmed network advantage - pertual and in use active. I can put a interface in routed l3 with "no switchport" command. Ospf works properly. Ip route work properly. If I type the command ping "IP" ...
Hi, here we have a same problem with IE3300. My devices (load controllers) works in 10mb half and his interfaces in ie3300 have a lot of fcs errors. In cisco IE3000 this issue not happen.We open a ticket on TAC and Cisco suggested apply "no ptp enabl...
