Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
does anyone have a link or any reading material for migration from WLSM to WiSM. Also quick questions for all the expert or any body thats done this before. 1. Is it safe to install both the WiSM and also the WLSM in the save chasis during m...
After upgrading to ver. 3.1.1.27 to my 3000 concentrator I was not able to save changes to the configuration manager of my Secure Desktop. I got a Modify Setting message but nothing happen when I click on save. Has anyone run into this problem befor...
thx for the reply and the link. I have that link it is the only link i can find on cisco site for this migration, but it still didnt answer most of my questions. I will take this up with TAC. This migration is a big process and there is only a 10 p...
your wlan is incorrectly setup. You want to add an interface of the vlan that is assign to a specific ssid so they can get the proper IP address. use link below this should solve your problem.http://cisco.com/en/US/docs/wireless/controller/3.2/conf...
1. Make sure that the time on your controller is correct. 2. Make sure your certificate time and dates are the right valid dates.If one and two are correct this will help solve your discovery problem for local vlan connection3. For LAP to connect...
Please see link below. For inter vlan to work you have to configure dhcp option 43 on your dhcp server. Hope this help you.http://cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00808714fe.shtml
hi,I had the same problem. the setting on your controller is wrong. set your controller wlan security for wpa + tkip....wpa2 + aes..key management 802.1x only.. *** only this combination will work with vista. If you enable cckm or check AES with ...
