Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, We have an ASR1002 that we use as PPPoE server and it gives private IPs (100.64.0.0/17) to PPPoE clients.We use nat to make them reach the internet as per lines attached.We can see that ASR uses only the first public IP of the pool "nat-pool",...
Hello, we have an ASR1002 router that's configured as pppoe server (with radius).clients connect with pppoe to our ASR and get public ip addresses.they all can reach the internet, however they all say that they cannot establish pptp sessions from the...
Hello everyone, we have an ASR-1002 up and running as pppoe server with radius auth, more than 500 subscriber sessions.We'd like to know if we can see mac address and some info about pppoe clients (brand and model of clients routers and so on)with sh...
Hello everybody, we are experiencing a strange problem in our ASR1002 behaviour when a PPPoE client connects for AAA.ASR1002 is a PPPoE server that checks credentials with radius. The clients authenticates correctly but then it does not receive any ...
Hello, this is the ASR config.Customers want to connect from home to office or from office to other external servers with PPTP+GRE tunnel.No problem if they change in L2TP tunnel but this workaround is not always acceptable. Current configuration : 1...
Hi, I can't under Virtual Template, because not all clients are Cisco router.If I add "cdp enable" in Virtual Template, a lot of clients stop connecting and I see a lot of errors in ASR1002 with incompatibility issues.
Hello Balaji, I see just the MAC address and the Virtual.interface, no info about brand and model of pppoe client. ASR1002#show pppoe session
548 sessions in LOCALLY_TERMINATED (PTA) State
548 sessions total
Uniq ID PPPoE RemMAC Por...
