Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,what are the exact ACL permit statements that i need to configure on my firewall if dhcp clients are residing on the inside network and DHCP server on the outside network, Assuming that i have access-group statments applied on both inside and o...
Topology: Router1 <->(outside)ASA(inside) <-> Router2IPSEC tunnel from Router1 to Router2with the routers being the IPSec Endpoints, do i need to explicitly permit ESP & ISAKMP on both the inside and outside interfaces in the inward direction of the ...
got one more question relating to ICMP - with icmp inspection enabled , when pinging from outside host to an inside host or from inside host to outside host - is it required to explicitly permit the return icmp traffic ?
If i have 2 interfaces with the same security level on ASA running 7.x code, with " same-security-traffic permit inter-interface " enabled and also an acl in place on both those interfaces, will the implicit permit be still effective between the same...
Hi, With icmp inspection turned off and " access-list inside permit ip any any " on the inside interface (access-group inside in interface inside) and "access-list outside permit icmp any any echo" on the outside interface (access-group outside in in...
did you get the same error message " No translation group found " with the static too.I believe you must be doing some kind of nat for "lyontwp-secure" network.and also check the nat VS Static. section at this linkhttp://www.cisco.com/en/US/docs/secu...
