About Burnt_Offering

Burnt_Offering · 04-28-2005

I have a question concerning ethernet ports on my Cisco routers. I am currently studying for my CCNA, and am trying to do a "Hands on Lab" scenario. I'm using the Todd Lammle Fifth Edition study guide. Page 232 if anyone has it. I have 3 Cisco 2500 s...

Burnt_Offering · 05-04-2005

OK, I finally got it. By piecing together what I already knew, and what you guys were telling me, I got it all working. I can now ping all the way accross 3 routers with the current config I have. All serial interfaces are up and running smoothly. So...

Burnt_Offering · 05-03-2005

Well believe it or not I'm really not trying to confuse the issue. The calbes I'm using say DTE on one end, and DCE on the other. I have tried applying a clock rate of 64000 just before the "no shut command. THe study guide is very thourogh on instru...

Burnt_Offering · 05-03-2005

Another question along the same lines. In my Lab scenario, my Serial interfaces will not stay up, and they ARE connected together using DTE cables. I can assign an ip address to Serial port 0, do the "no shut" command, and it will show "up" for about...

Burnt_Offering · 04-29-2005

Very cool, thanks again guys for the info

Burnt_Offering · 04-29-2005

Thanks For the info Kevin. So the next question would be, when would it ever be appropriate to use that command if there is something connected to the interface?

Member Since	‎03-01-2005 01:29 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	7

User Statistics

User Activity

Ehternet Question

Re: Ehternet Question

Re: Ehternet Question

Re: Ehternet Question

Re: Ehternet Question

Re: Ehternet Question