Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I currently have a router on a stick configured for a router to switch connection to route VLANS but I want a better way to do it. First off I have an ASR router and WS-C3560X-48 layer 3 switch. I would like to have a layer 3 connection conne...
HI I have 2 public IPs coming over a single circuit terminating in a firewall (Cisco ASA 5525) One is for a SIP trunk and one is for Internet connectivity. I am wondering how to configure the firewall interface to use both Public IPs on the single in...
yeah all work will be done out of hours. So, when work is complete I could still have the L2 switching network with one of the switches act as the router? I am thinking after all work is complete the network will perform the way it should.
Super, yeah makes sense.. Enabling ip routing, will that effect the current state of the switch? Currently it's part of a 4 switch L2 network and I really don't want to isolate the switch in any way. So my aim here is to send the VLANs to the switch ...
This is exactly what I need to do. My confusion was coming from the physical interface being originally configured with a public IP just for Internet and additional IP added for SIP trunk and had me scratching my head how both Public IPs will come in...
I am not sure how the ISP are routing but originally it was a single public IP for internet connectivity to the FW interface and we had to add second public IP to that link for a SIP trunk. I think NAT the second IP for the SIP trunk is the way forw...
