Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
After upgrade to 3.6 I noticed the strange behaviour - can't access configuration section in Web GUI. Also ssh stopped working. It seems like a bug:
CSCuw20068 - Displays only Home and Monitor web GUI options. Is there any workaround to acces...
Hi All,
I followed the process https://supportforums.cisco.com/discussion/12169071/upgrade-wlcs-firmware-high-availability-ap-sso-enabled#comment-9628051, before reboot all APs looked like this:
Predownload Predownload FlexconnectAP Name Primary Imag...
I checked the console and looks like I can't use it - there is a lot of messages going and I can't type anything. Is there a way to use some direct URL in the GUI?
Hi All,
The version is 3.6.3 from memory. I will try to get console access and verify "ip http" commands and will let you know. Must be those commands in the config?
Thanks,
Roman
Ok, just wanted to say thanks for all suggestions. Fortunately we did not have to go the "reset AP" way.
It appeared that those APs for some reason did not swap their images and joined other controller with old version. That was something totally une...
OK, thanks, we don't have remote access now, we'll try to get console access. If we can do it, we'll try your suggestion. In case the person can't access console, the only option would be to re-set AP. The router on that site supports DHCP so we can ...
Hi Leo,
Thank you for feedback. Do you mean that I need to repeat the upgrade process? 98% of APs successfully joined WLC and work fine, may be I can just re-set those 4 APs to default and let them connect to WLC again? For Bootstrap upgrade, is ther...
